No, it does not support. It is necessary to switch over the remote control in static operation mode for work with 8117 UPM radio card.
Change of operation mode for Radio 8101-1M Remote Control:
Actions
Press the remote control button 4 times in a row, then press and hold it for more than 4 sec. Interval between pressings should not exceed 1 sec.
Press the remote control button and hold for more than 1 second to change operation mode. The modes are switched circle-wise each time you press.
Indication
- two times – dynamic operation mode (factory setting);
- once – static operation mode.
Change of operation mode for Radio 8101-2M and Radio 8101-4M Remote Controls:
Actions
Press any remote control button and hold it, then press short another button. Hold the first button till the end of programming.
Press short any other remote control. The modes are switched circle-wise each time you press the second button.
Indication
- two times – dynamic operation mode (factory setting);
- once – static operation mode.
No, operation of the remote control is possible only using one mode.
No, it is impossible. When working with the Radio 8615 device, you can add, remove remote controls and change their settings only using USB-stick.
The Nero II 8761 UPM transcoder is used to increase the range capability when working with devices of these ranges.
No, they are not compatible.
You should use the executive devices of Radio range with the retransmission command.
The retransmission command is supported by all Radio 8113 IP65 devices manufactured later than October 2018. To activate the retransmission command, you should press and hold the programming button for more than 8 sec. After the first green flash, release the button, then press it again and hold for more than 1 sec. Indication: 2 green flashes - retransmission is turned on.
Attention! Only the dynamic code is retransmitted!